INETVU 7000 CONTROLLER DRIVER

Page 2 of This page is intentionally left blank. The third character refers to the looping intervals between tests i. Page 31 of AZ Displays real-time current drawn and speed settings for the azimuth motor, as well as real-time azimuth angle and limits, search window size, zero and pot factor. Network Cable Power Cable Fig. DVB will base satellite acquisition on three satellite transponder parameters, them being:

Uploader: Gardaramar
Date Added: 18 November 2013
File Size: 46.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 55413
Price: Free* [*Free Regsitration Required]

Page 33 of 7.

Compass Direction And System Ref. Page of Test Compass Positions Antenna to a level Elevation angle and updates compass heading. The update process is displayed on screen and will notify the user when the process dontroller complete.

The following are the Interface options to select from: In this case, a splitter must be used for the RF connection as depicted in the figure below. When taking the direction on the alternate compass, take the direction conrtoller your reading while facing the front of the vehicle, and use this orientation for the Vehicle Direction field.

TC Communications – iNetVu Controller

Beacon Receiver is not used, this field can be ignored. Otherwise, this field is not applicable. Then select your GPS settings for communicating with the modem such as your baud rate usually or Page 68 This field allows the user to inetvh a fixed offset for the target polarization angle. Page 98 of speed 6 and 9.

Related Drivers  D LINK 502T DRIVER DOWNLOAD

INetVu 7000 Series User Manual

See Appendix for VDC power input external cable connectivity wiring. For a more detailed explanation of each menu, see the configuration section of this manual.

Page 9 of 1. I unfortunetly did not work on the problem anymore, will only do so again in a few weeks. Orbital Slot Location of Configured Satellites The target and Reference satellites section displays the satellite longitude for each configured satellite.

ERR Contains information pertaining to the error code if an error occurs. Antenna will center itself and attempt to locate the cut-off edges of the Polarization Stow Switch. See Appendix 3 for a list of all the elevation offset default values. Page 11 of 2.

The PL Zero may vary A message prompt will appear to notify you that the Compass Calibration has been completed successfully or not. Page 3 This document contains information, which is protected by copyright. Browse for the proper firmware. Warning signs shall be posted at prominent locations on the earth station informing all persons of the danger of harmful radiation from the earth station while it is deployed or while in operation.

Related Drivers  INTEL ICH7M MDH SATA AHCI CONTROLLER DRIVER DOWNLOAD

Ex Member Ex Member. By default the boxes are left unchecked.

VSAT Antenna Controller 7000/7024

Installers shall be liable for all damages if they fail to comply with the above mandatory conditions. E — Enable Limit Once enabled, the up, down and stow limits will be activated whenever the up, down, and stow TM sensors have been triggered on the iNetVu Mobile platform.

Also See for Series User manual – 20 pages Instruction manual – 20 pages. Should the Signal Strength be lower than 29 when locked on satellite, click Find Satellite again to re-acquire the signal.

INETVU SERIES USER MANUAL Pdf Download.

Installers and end users will be deemed directly liable for controllef damages resulting from either of their failure to comply with the above rules. Page of 6. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this instruction manual, may cause harmful interference with radio communications.